Thank you for the response.
The problem is, that I need to send (and constantly update) 24 different parameters in real-time. I tried the same before using midi, which functioned without any noticeable delay.
However, OSC can is able to transmit the data more accurate due to limited bit-depth of midi.
Therefore, my idea was to put all 24 messages into one.
I am not quite sure what you mean by sending them “in a bundle together”. In my patch now, every message gets created separately but “at the same time” (one after another according to pd signal flow).
kind regards and thank you in advance
Patrick
On 21.05.2020, at 23:44, Martin Peach chakekatzil@gmail.com wrote:
On Thu, May 21, 2020 at 5:19 AM Patrick Heidegger via Pd-list pd-list@lists.iem.at wrote:
Hello all,
I want to send controls for multiple fx-parameters in Reaper with a single OSC-message. Controls for multiple parameters in reaper are defined like:
/track/1/fx/2/fxparm/x1,x2,x3,x4/value y1 y2 y3 y4
where xn are the parameter index and yn are the assigned values. I know that commas in PD usually can not be used in this way.
Is there any workaround?
If you want to send y1 to/track/1/fx/2/fxparm/x1 and y2 to /track/1/fx/2/fxparm/x1x2 etc. , just make four separate messages like /track/1/fx/2/fxparm/x1 y1 They could be in a bundle together. If you want to send all the ys to each of the four endpoints then it should be written* : /track/1/fx/2/fxparm/{x1,x2,x3,x4} y1 y2 y3 y4 ...which is problematic in Pd because of the way text input is interpreted as TCL at some points, so again it's easier to make four separate messages. In a bundle they will have a timestamp so they will act simultaneously.
Martin
*http://opensoundcontrol.org/spec-1_0 "OSC Message Dispatching and Pattern Matching"