I'm desparate...Can anyone help?
Here's the scenario:
I'm running pd on my i486 (Win 95) sending MIDI data to my Pentium (Win 98) over MIDI cables to a sequencer.
After using I shut down the sequencer before shutting down pd.
The 486 rebooted and stopped with the error message:
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER
I've done this and I can change to the c: drive and list the files.
My d: drive is anavailable through the prompt (although it is present in the bios settings and was successfully autodetected).
Fdisk gives the following under 'change current fixed disk drive':
Disk / Drive / Mb / Free / Usage 1 / [nothing] / 163 / 163 / [nothing]% 2 / [nothing] / 204 / [nothing] / 100% [nothing] / C: / 204 / [nothing] / [nothing]
Display partition information for disk 1 reads:
No partitions defined
The same for 2 reads:
Partition: c: 1 / Status A / Type: PRI DOS / Vol label: MS-DOS_6 / Mb: 204 / System FAT16 / usage 100% Total disk space is 204 Mb.
I know this isn't a PD issue (although it may have been caused by PD and would therefore be of interest) but I would really, really appreciate any guidance.
Thanks,
Richard.