On 05/26/2013 05:05 PM, James Dunn wrote:
Hi,
I have installed Arch linux on my Raspberry Pi and am logging in with ssh -Y raspberrypi.local. I can run xterm fine over the connection but pd fails with no information other than:
$ pd priority 6 scheduling enabled. priority 8 scheduling enabled. watchdog: signaling pd... pd: exiting
If I set the debug level to 5 I get the following information:
$ pd -d 5
this is of not much use unless you want to debug the pd<->gui connection.
try instead: "-v" (for verbose) "-v -v" (for more verbosity)
other flags you might want to check (in any combination) "-nogui" (see whether Pd can start without the gui) "-nosound" (does the sound-card give you trouble?) "-noprefs" (stupid preference file?)
my bet is, that your soundcard is the culprit, e.g. Pd doesn't handle the case well, where you only have half-duplex (e.g. playback only) and your are using alsa. if that's the case ("-nosound" should run ok), try "-noadc" or "-nodac" (without the "-nosound"))
famsdr IOhannes