You need to match the versions of the Firmata on the Arduino and the
Firmata on Pd. Also, you should not use Firmata from Arduino 0017,
its buggy. Use Arduino 0018.
For ATMEGA8 using OldStandardFirmata, but before uploading, change the
baud rate in setup() to 57600. That's the only change from Firmata
V2.0 to V2.1. V2.0 is 115200 and V2.1 is 57600. Arduino now uses
57600 for everything.
.hc
On Mar 9, 2010, at 10:10 AM, Derek Holzer wrote:
Yes proper FTDI drivers installed.
The Analog Firmata works, however the Standard Firmata is totally
broken.D.
On 3/9/10 4:27 PM, Greg Pond wrote:
do you have the proper ftdi drivers installed? http://www.ftdichip.com/Drivers/VCP.htm
good luck.
On Tue, Mar 9, 2010 at 7:22 AM, Derek Holzer <derek@umatic.nl mailto:derek@umatic.nl> wrote:
Hi all,
I'm in the middle of a workshop right now, and nothing I planned works. All the users on OSX cannot use the Pduino objects. They
all have latest Pd-Extended 0.41.4 and latest Pduino-0.5beta6. They
have all successfully loaded the Standard-FirmataV2 (the Standard- Firmata is too big for the Atmega8) to an Arduino NG w/ Atmega8.Then they open arduino-help.pd, use "devices" to determine the proper port and set the port.
Then I have them test with "pinMode 13 1" followed by "digital 13 1". I see the RX LEDS flash, but the pin 13 LED does nothing.
Then I open [pd DIGITAL-OUTPUT] and use that patch to flash all the
digital outputs, after setting them to output mode in the main patch.
Again, RX lights blink but nothing else.After that I get long strings of the following:
UNKNOWN INPUT COMMAND: 8 32120 [arduino] warning currently unsupported 160 [arduino] warning currently unsupported 176
This is consistent across every installation, whether PPC or
Intel. We can't really go further with Arduino without fixing this, so I hope someone can help.In contrast, I am using Pduino04.beta2 with Pd-extended-0.39 on my machine and everything works fine. I have also been unble to run
any Pduino with Pd-extended-0.41.4. Installing Pduino04.beta2 with Pd-extended-0.39 on a couple of machines of the students hasn't
been an effectivbe workaroundm however ([arduino-help.pd] crashes Pd in this case).Any suggestions welcome. Is there something I totally missed
here????D.
-- ::: derek holzer ::: http://macumbista.net ::: ---Oblique Strategy # 48: "Discover your formulas and abandon them"
Pd-list@iem.at mailto:Pd-list@iem.at mailing list UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list
-- ::: derek holzer ::: http://macumbista.net ::: ---Oblique Strategy # 158: "Think of the radio"
Pd-list@iem.at mailing list UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list
Mistrust authority - promote decentralization. - the hacker ethic