José

2011/4/13 Jose Luis Santorcuato <santorcuato76@gmail.com>

Hi, maybe you must change in the Arduino IDE the baud to comunicate...in Arduino terminal...
in the tabs to upload, run,stop, etc, find the last (on right) which corresponds to terminal, open it and setup the baud of Arduino, do not quite understand what you say, but might work.

Check the pic

http://emulare.sourceforge.net/manual/ArduinoTerminal.jpg

In Linux is the same

Best regards

José

2011/4/13 J bz <jbeezez@gmail.com>

Hi all,

Just transferring a patch into Linux from W7 and I get this message in the console which I didn't previously:
get_baud_ratebits: 115200
set_baudrate baudbits: 4098

Now I want the baudrate to be 115200, which is good but what does the baudbits info mean - for example is it telling me that data is only coming in at 4098? Which I don't want, or, seems a waste if the overall patch is expecting a much faster rate.

Cheers,

Julian

_______________________________________________
Pd-list@iem.at mailing list
UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list

--
http://arselectronicachile.blogspot.com
http://comunicacionnativa.blogspot.com/
http://www.myspace.com/santorcuato

--
http://arselectronicachile.blogspot.com
http://comunicacionnativa.blogspot.com/
http://www.myspace.com/santorcuato