Hi,
I'm guessing that mrpeach/udpreceive and netreceive have different polling behavior that can explain this, but I don't see it yet. Is there anyone reading, who's dealt with this issue before?
They actually use the same polling mechanism. I tried to receive OSC messages with [mrpeach/udpreceive] while running it batch mode and it doesn't work, just like I expected. Are saying this works for you? I would be quite surprised...
As the ticket on sourceforge mentions, there's no explicit call to sys_pollgui() in batch mode *) - which by the way is a misnomer because it polls *all* sockets -, so I don't see how [mrpeach/udpreceive] could work under such circumstances.
I have been writing a patch to send messages to/from a subprocess in batch mode. First, I wrote the patch with mrpeach's udpsend/udpreceive and got it working. It's just a simple handshake:
I think the real problem is that you're using batch mode for the wrong job. In batch mode, Pd will run as fast as possible to get a certain task done. If you wait for incoming network traffic while in batch mode, you're just busy waiting and wasting lots of CPU cycles. Just use Pd in realtime mode instead!
Or is there a specific reason why you think you need to receive messages while running in batch mode?
Here the cpu load goes to 100%
This is totally expected, as you want to run your task as fast as possible.
Christof
*) to be correct, there is a hidden call to sys_pollgui() if there are more than 5000 clock timeouts in a given scheduler tick (see sched_tick())
Gesendet: Montag, 27. Januar 2020 um 02:20 Uhr Von: "Charles Z Henry" czhenry@gmail.com An: Pd-List pd-list@lists.iem.at Betreff: [PD] netreceive vs mrpeach/udpreceive in batch mode
Hi list,
I have been writing a patch to send messages to/from a subprocess in batch mode. First, I wrote the patch with mrpeach's udpsend/udpreceive and got it working. It's just a simple handshake:
the toplevel process starts listening on port 16000 for a message [1 1(. When it receives that message, it sends back a message [1 subprocess#( to localhost port 15999.
The subprocess starts up, listens on port 15999 and sends a message [1 1( to localhost port 16000. When it gets a message [1 n( on port 15999, it outputs n as the subprocess #, and opens a new port 16000+n (and closes 15999).
This was fine, except udpsend/receive pairs exchange binary numbers (0-255). It will work, but it doesn't make the patches as easily readable. It will still be possible to pass integers larger than 255 with a little patching, but some flexibility would be nice.
I thought "netsend -u"/"netreceive -u" would make a good replacement with text instead.
It runs fine during the first part of testing with the GUI. I test "-nogui". Also fine. Then, "-batch" added. Here the cpu load goes to 100% (which didn't happen with mrpeach udpsend/receive). I'm able to strace and see the first message [1 1( sent. Then, the process keeps on going but doesn't receive any further UDP messages.
I'm able to find a sourceforge ticket from 2012: https://sourceforge.net/p/pure-data/bugs/943/ and basically, I'm looking for the same usage case which is batch mode processing under supervision from another Pd process.
I'm guessing that mrpeach/udpreceive and netreceive have different polling behavior that can explain this, but I don't see it yet. Is there anyone reading, who's dealt with this issue before?
Chuck
Pd-list@lists.iem.at mailing list UNSUBSCRIBE and account-management -> https://lists.puredata.info/listinfo/pd-list