2010/5/19 Ricardo Lameiro <ricardolameiro@gmail.com>

I also forgot to mention that this issue was mentioned on this list before.

there is a link for a firmata firmware made for the mega from the made by the teensy guy.

http://www.pjrc.com/tmp/firmata/

check the list in here
http://www.mail-archive.com/pd-list@iem.at/msg31148.html

2010/5/19 Ricardo Lameiro <ricardolameiro@gmail.com>

As far as I know, the pduino is not made for the arduino mega. so it could work, but you need to test it out. also the firmata firmware would need also some tweak since the mega has more outputs/inputs and analog ports

2010/5/19 Andres Ferrari <anfex@yahoo.com>

hello,
When I use the abstraction [arduino] or [comport] object
the numbers of the digital outputs (pins) of the arduino hardware
don't match with the output's numbers of the patch.

for example, when i send 1 to digital output "12" from puredata the led connected to digital out 12 don't turn on but ...but turn on in digital out "14"...

only works pins from 10- 13 but 0- 9 dont't work.

When I've tested from the arduino's software with a sketch there aren't any problem, all works fine.

Is it a [comport]r or "Firmata" problem?
I have osx 10.5 and arduino mega.

Any suggestions?.....thanks a lot!!!

Andrés Ferrari G.

http://www.myspace.com/anfex

_______________________________________________
Pd-list@iem.at mailing list
UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list

--
Fagote / Contrafagote
Bassoon / Contra-bassoon
http://myspace.com/ricardolameiro

--
Fagote / Contrafagote
Bassoon / Contra-bassoon
http://myspace.com/ricardolameiro

_______________________________________________
Pd-list@iem.at mailing list
UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list