Well.... check the arduino firmata program (arduino ide).... the outputs.... 13? 16? when i work with bluetooth i needed change the baud... to 115.200, many programs in arduino ide have a problems...I test the firmata teensy...
Best regards
José
2010/5/19 Ricardo Lameiro ricardolameiro@gmail.com
I also forgot to mention that this issue was mentioned on this list before.
there is a link for a firmata firmware made for the mega from the made by the teensy guy.
http://www.pjrc.com/tmp/firmata/
check the list in here http://www.mail-archive.com/pd-list@iem.at/msg31148.html
2010/5/19 Ricardo Lameiro ricardolameiro@gmail.com
As far as I know, the pduino is not made for the arduino mega. so it could
work, but you need to test it out. also the firmata firmware would need also some tweak since the mega has more outputs/inputs and analog ports
2010/5/19 Andres Ferrari anfex@yahoo.com
hello, When I use the abstraction [arduino] or [comport] object the numbers of the digital outputs (pins) of the arduino hardware don't match with the output's numbers of the patch.
for example, when i send 1 to digital output "12" from puredata the led connected to digital out 12 don't turn on but ...but turn on in digital out "14"...
only works pins from 10- 13 but 0- 9 dont't work.
When I've tested from the arduino's software with a sketch there aren't any problem, all works fine.
Is it a [comport]r or "Firmata" problem? I have osx 10.5 and arduino mega.
Any suggestions?.....thanks a lot!!!
Andrés Ferrari G.
Pd-list@iem.at mailing list UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list
-- Fagote / Contrafagote Bassoon / Contra-bassoon http://myspace.com/ricardolameiro
-- Fagote / Contrafagote Bassoon / Contra-bassoon http://myspace.com/ricardolameiro
Pd-list@iem.at mailing list UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list